Increase performance and flow with our upgraded 3 inch Max Flow Bridge and Cold Side Kit. Our precision cast and CNC machined bridge section allows for maximum efficiency, as well as a perfect fit every time. Our two-piece design allows for a much easier installation than the other kits on the market. Two M8 studs, 12-point nuts, and a high-strength O-ring locate and hold the 3 inch bridge together to eliminate the possibility of boost leaks.
Our bridges have been pressure tested to over 100 PSI to ensure your truck can perform to its highest potential.
The mandrel bent 3 inch cold-side tube complements the y-bridge for the ultimate efficiency, flow, and maximum performance capabilities of your truck.
We also designed a new alternator cover for 08-10 trucks that relocates the power wire from the top of the alternator to the back like the older trucks, to give you that little bit of extra clearance for a perfect low profile fit. The alternator cover is 3D printed and includes a spacer and nut stud combo to secure the power wire to. There is no need to cut or extend any wires.
This versatile kit is designed for the future progression of your truck. It allows you to upgrade to HSP's compound set-up in the future. If running with a stock charger, an HSP Diesel intake is highly recommended to avoid fitment issues. Contact HSP directly if you are uncertain about your application.
- 2007.5-2010 Chevrolet / GMC
- Upgraded 3 inch Max Flow Bridge and Cold Side Kit
- Mandrel bent 3 inchÂ cold-side tube
- Pressure tested to over 100 PSI
- White Finish
- Made In The USA
- Sold As A Kit